U60-B Bi-Color 2-Light Softbox Kit Setup Guide

By Westcott | Published: 2026-10-29

Category: How-to Guides

Learn how to set up the Westcott U60-B Bi-Color 2-Light Softbox Kit step by step. Includes key assembly tips and common mistakes to avoid for studio lighting.

Quick answer

Assemble the U60-B softbox kit by attaching the speed ring, mounting the LED light, and adjusting bi-color output for consistent studio lighting.

Why proper softbox assembly matters

A correctly assembled softbox ensures even, diffused light without hotspots or shadow lines. The U60-B's 60W bi-color LED provides adjustable color temperature (3200K–5600K), but poor setup can negate its benefits. Take a few extra minutes to align rods and fabric snugly.

Common mistakes to avoid

Skipping the inner baffle causes harsh light and uneven diffusion. Forgetting to lock the speed ring can lead to the softbox slipping mid-session. Also, avoid over-tightening wing nuts on the light stand—hand-tight is sufficient.

Setup steps

Unpack and identify parts: Remove the two LED lights, two softboxes, speed rings, light stands, and power cables from the case. Check that each softbox rod is undamaged and the inner baffle is present. Missing or bent rods will cause uneven fabric tension.
Assemble the softbox frame: Insert the flexible rods into the speed ring one at a time, then slide the opposite ends into the softbox corners. Work in a cross pattern to avoid stressing the fabric. Rushing this step can snap a rod or tear the fabric.
Attach the inner baffle and front diffuser: Place the inner baffle (white fabric) over the speed ring, then snap the front diffuser over the softbox opening. Ensure Velcro strips are fully engaged to prevent light leaks. A loose baffle creates a hot spot in the center of your light.
Mount the LED light to the stand: Screw the U60-B light onto the stand's stud, then tighten the tilt lock handle. Connect the power cable and press the power button to test. Always tighten the lock handle—lights can tilt unexpectedly if loose.
Attach the softbox to the LED light: Align the speed ring's locking pins with the light's mounting plate, then twist clockwise until it clicks. Verify the softbox is secure before releasing. A half-twisted speed ring can detach and damage the softbox.
Set bi-color output and position: Use the rear dial to adjust color temperature (3200K–5600K) and brightness (1–100%). Position the light at 45° to your subject for classic portrait lighting. Starting at 5600K gives a neutral daylight base; dim to 50% for softer fill.

Product facts

U60-B Bi-Color LED 2-Light Softbox Kit: The U60-B Bi-Color LED 2-Light Softbox Kit includes two 60W bi-color LED lights, two softboxes, stands, and carry bags. You get everything needed for a complete two-light setup out of the box, saving time sourcing separate components.
U60-B Bi-Color LED 2-Light Softbox Kit